LVF阀门

Stainless steel flame arresters are usually installed on storage tanks and pipelines that transport or discharge flammable and explosive gases. Such as torches, heating and combustion systems, petroleum gas recovery systems, or other flammable gas systems.

 

Installation and maintenance of stainless steel flame arresters

 

1. To ensure the performance of the flame arrester meets its intended use, it is necessary to carefully read the instruction manual and verify whether the label matches the requirements of the installed pipeline before installing the flame arrester.

 

2. The flow direction mark on the flame arrester must be consistent with the flow direction of the medium.

 

3. Stainless steel flame arresters should be inspected every six months. Check whether the fire-resistant layer has defects such as blockage, deformation, or corrosion.

 

4. The blocked fire-resistant layer should be cleaned thoroughly to ensure that each hole is unobstructed, and any deformed or corroded fire-resistant layer should be replaced in a timely manner.

 

5. When cleaning the flame arrester core components, high-pressure steam, non corrosive solvents, or compressed air should be used for blowing, and sharp hardware brushes should not be used.

 

6. When reinstalling the flame retardant layer, the gasket should be updated to confirm that the sealing surface is clean and undamaged, and there should be no air leakage.

 

7. If the core of the stainless steel flame arrester is found to be mechanically damaged or corroded by the medium, it should be replaced immediately.